Why Use Protective Boat Coatings? | The Marine Expert’s Guide

WHY BOAT DETAILING WITH PROTECTIVE BOAT COATINGS?

 

THE PROVEN SYSTEM TO END TRADITIONAL BOAT DETAILING

Boat detailing the traditional way with waxes and polishes is now old-fashioned, time-consuming and expensive when compared with a high-gloss coating system. Protective boat coatings are the ultimate solution for superior protection!

BOAT DETAILING THAT LASTS AND LASTS

Firstly: Have you ever had your boat detailed, the one with a traditional polish and finishing wax applied? However, only to notice that after just a few weeks, your gel-coat was faded and chalky again?

It’s pretty annoying, isn’t it?

Hi-gloss protective and marine coatings of Innovative Marine Coating is an Australian company based in Sydney, New South Wales. We pride ourselves on long-lasting solutions for the marine industry.  Let’s face it, we don’t like polishing boats either, just to have them looking worn again in a few weeks.

As a result, marine experts everywhere started thinking: there must be a better way. And there really is!

Also, high-gloss protective and marine coatings system last 9 months to 2 years without reapplication or polishing required in the mean time. In contrast to traditional boat detailing, you can trust that your protective boat coatings will last!

Just take care of your boat the normal way, with a PH neutral boat wash.  Don’t be afraid of the coating coming off…it is solid and made to withstand the high UV and salt exposure that gets thrown at it in normal boat use.

Additionally, the 92% gloss level achieved with our coatings brings the boat back to near-new gloss (showroom is around 95%).  As a comparison, dull gel-coat will often be around 30% and chalky about 5-10%.

protective boat coatingsHI-GLOSS PROTECTIVE AND MARINE COATINGS COMPARISON CHART

COST GLOSS UNITS – DROP OVER 3 MONTHS SERVICE TIME

MACHINE POLISHING $2,200 57 EVERY 4 MONTHS
IMC SYSTEM $2,600 22 EVERY 12

THE RESULTS WERE BASED ON THE FOLLOWING:

1- 40FT FLY BRIDGE CRUISER

2- AUSTRALIAN UV CONDITIONS

3- GLOSS METER USED WAS A 60 DEGREE SINGLE ANGLE THERMO FISCHER UNIT

4- MACHINE POLISHING COST IS AN AVERAGE TAKE FROM SELECTED FULLY ENSURED SERVICE PROVIDERS

Finally, if you have any questions or ideas for your next project: Contact Us!

%d bloggers like this: